Derivatives of benzo[b]furan. Part I. Conformational studies of khellinone and visnaginone

Structural Chemistry - The structural analysis of khellinone and visnaginone indicated the planarity of the benzo[b]furan ring system. The oxygen or carbon atoms of the substituents, –OH,...     

Effects of low-dose ionizing radiation on α,β-globulins solutions studied by DSC

An attempt has been made to detect the effect of a small dose of ionizing radiation on the course of α,β-globulin thermal denaturation in aqueous solutions. Doses of 0.1 and 1.8 Gy have been delivered using γ-rays emitted by ⁶⁰Co isotope while doses of 10 and 100 Gy have been supplied by X-rays produced by linear accelerator. The highest dose has visibly changed DSC curve of protein solution while the changes due to lower doses are hardly detectable. Although very weak, the irradiation effect found has been dose dependent. The results suggest that the influence of ionizing radiation on globulins solution is bigger when the dose rate is lower at given dose. The opposite direction of differences between irradiated and control samples for fresh and stored protein solutions suggests various characters of changes in initial and later period of sample aging. This may be an important reason for difficulties in an investigation of the effect of ionizing radiation on protein solution, especially for low doses delivered very slowly.     

Novel 3-Acetyl-2,5-disubstituted-1,3,4-oxadiazolines: Synthesis and Biological Activity

The aim of our study was the two-stage synthesis of 1,3,4-oxadiazole derivatives. The first step was the synthesis of hydrazide–hydrazones from 3-methyl-4-nitrobenzhydrazide and the corresponding substituted aromatic aldehydes. Then, the synthesized hydrazide–hydrazones were cyclized with acetic anhydride to obtain new 3-acetyl-2,3-disubstituted-1,3,4-oxadiazolines. All of obtained compounds were tested in in vitro assays to establish their potential antimicrobial activity and cytotoxicity. Our results indicated that few of the newly synthesized compounds had some antimicrobial activity, mainly compounds 20 and 37 towards all used reference bacterial strains (except Klebsiella pneumoniae, Proteus mirabilis, and Pseudomonas aeruginosa) and fungi. These substances showed a strong or powerful bactericidal effect, especially against Staphylococcus spp. belonging to Gram-positive bacteria. Compound 37 was active against Staphylococcus epidermidis at minimal inhibitory concentration (MIC) = 0.48 µg/mL and was characterized by low cytotoxicity. This compound possessed quinolin-4-yl substituent in the second position of 1,3,4-oxadiazole ring and 3-methyl-4-nitrophenyl in position 5. High effectiveness and safety of these derivatives make them promising candidates as antimicrobial agents. Whereas the compound 20 with the 5-iodofurane substituent in position 2 of the 1,3,4-oxadiazole ring showed the greatest activity against S. epidermidis at MIC = 1.95 µg/mL.     

Indirect and Direct Grafting of Transition Metals to Siliconoids

Unsaturated charge‐neutral silicon clusters (siliconoids) are important as gas‐phase intermediates between molecules and the elemental bulk. With stable zirconocene‐ and hafnocene‐substituted derivatives, we here report the first examples containing directly bonded transition‐metal fragments that are readily accessible from the ligato‐lithiated Si₆ siliconoid ( 1Li ) and Cp₂MCl₂ (M=Zr, Hf). Charge‐neutral siliconoid ligands with pending tetrylene functionality were prepared by the reaction of amidinato chloro tetrylenes [PhC(NtBu)₂]ECl (E=Si, Ge, Sn) with 1Li , thus confirming the principal compatibility of such low‐valent functionalities with the unsaturated Si₆ cluster scaffold. The pronounced donor properties of the tetrylene/siliconoid hybrids allow for their coordination to the Fe(CO)₄ fragment.     

Experimental study on heat transfer of thermally developing and developed, turbulent, horizontal pipe flow of dilute air-solids suspensions

Heat transfer characteristics of a turbulent, dilute air-solids suspension flow in thermally developing/developed regions were experimentally studied, using a uniformly heated, horizontal 54.5 mm-ID pipe and 43-μm-diameter glass beads. The local heat transfer was measured at 27 locations from the inlet to 120-dia downstream of the heated section over a range of Reynolds numbers 3×10⁴−1.2×10⁵ and solids loading ratio 0–3, and the fully developed profiles of air velocity/temperature and particle mass flux were measured at a location 140-dia downstream of the heated section using specially designed probes, inserted into the suspension flow. The effects of the Reynolds number, solids loading ratio, and azimuthal/longitudinal locations on the heat transfer characteristics and their interactions are discussed through comparison of the present results with the data obtained by other investigators. Received on 14 October 1996     

Calix[n]arenes as components for the construction of micellar systems: synthesis and self-assembly properties of 5,11,17-Tris[(dimethylamino)methyl]-25-monoalkoxy-26,27,28-trihydroxycalix[4]arene derivatives

A series of mono-O-alkylated calix [4] arenes derivatives, with alkyl chain lengths of between 1 and 12 carbon atoms are reported. Monoalkylation is best achieved using potassium carbonate as the weak base and the respective alkyl iodide for chain lengths of one to three carbon atoms and using caesium fluoride as the base and the respective alkyl iodide for longer chain lengths. The mono-alkylated derivatives were converted into the tri-para-dimethylaminomethylene derivatives by the para-quinonemethide reaction in good yields. Surface tension measurements showed that at pH 2, 4, 6 and 8 all the tri-dimethylaminomethylene derivatives showed surfactant behaviour, and at pH 2 all show a Critical Micellar Concentration values. No correlation between Critical Micellar Concentration values and chain length is observed. Dynamic Light Scattering measurements showed that the CMC behaviour may be correlated with the observed aggregate sizes. The solid state structure of mono-O-ethoxy-calix[4]arene is described, in this structure a 1-D inclusion polymer is observed.     

Encapsulating Metal Nanoparticles into a Layered Zeolite Precursor with Surface Silanol Nests Enhances Sintering Resistance**

Supported metal nanoparticles are used as heterogeneous catalysts but often deactivated due to sintering at high temperatures. Confining metal species into a porous matrix reduces sintering, yet supports rarely provide additional stabilization. Here, we used the silanol-rich layered zeolite IPC-1P to stabilize ultra-small Rh nanoparticles. By adjusting the IPC-1P interlayer space through swelling, we prepared various architectures, including microporous and disordered mesoporous. In situ scanning transmission electron microscopy confirmed that Rh nanoparticles are resistant to sintering at high temperature (750 °C, 6 hrs). Rh clusters strongly bind to surface silanol quadruplets at IPC-1P layers by hydrogen transfer to clusters, while high silanol density hinders their migration based on density functional theory calculations. Ultimately, combining swelling with long-chain surfactant and utilizing metal-silanol interactions resulted in a novel, catalytically active material—Rh@IPC_C22.     

Optimum collision energies for proteomics: The impact of ion mobility separation

Ion mobility spectrometry (IMS) is a widespread separation technique used in various research fields. It can be coupled to liquid chromatography–mass spectrometry (LC–MS/MS) methods providing an additional separation dimension. During IMS, ions are subjected to multiple collisions with buffer gas, which may cause significant ion heating. The present project addresses this phenomenon from the bottom-up proteomics point of view. We performed LC–MS/MS measurements on a cyclic ion mobility mass spectrometer with varied collision energy (CE) settings both with and without IMS. We investigated the CE dependence of identification score, using Byonic search engine, for more than 1000 tryptic peptides from HeLa digest standard. We determined the optimal CE values—giving the highest identification score—for both setups (i.e., with and without IMS). Results show that lower CE is advantageous when IMS separation is applied, by 6.3 V on average. This value belongs to the one-cycle separation configuration, and multiple cycles may supposedly have even larger impact. The effect of IMS is also reflected in the trends of optimal CE values versus m/z functions. The parameters suggested by the manufacturer were found to be almost optimal for the setup without IMS; on the other hand, they are obviously too high with IMS. Practical consideration on setting up a mass spectrometric platform hyphenated to IMS is also presented. Furthermore, the two CID (collision induced dissociation) fragmentation cells of the instrument—located before and after the IMS cell—were also compared, and we found that CE adjustment is needed when the trap cell is used for activation instead of the transfer cell. Data have been deposited in the MassIVE repository (MSV000090944).     

2,2′-Dithiobispyrazine: about the disulfide bond

X-ray diffraction studies reveal that pyrazine-2-thiol undergoes condensation to 2,2′-dithiobispyrazine [systematic name: 2-(pyrazin-2-yldisulfanyl)pyrazine], C₈H₆N₄S₂ ( I ), under aerial conditions. In the molecule of I , the pyrazine rings are arranged in an almost perpendicular manner, with an absolute value of the C—S—S—C torsion angle of −91.45 (6)°. A search in the Cambridge Structural Database confirmed that such a conformation is typical for disulfide compounds. Three different rotamers of disulfide I were studied using quantum theoretical studies. The rotamer of lowest energy was observed in the crystalline state in the structure stabilized by hydrogen-bond, chalcogen-bond and stacking interactions. Further quantum chemical computations confirm that 2,2′-dithiobispyrazine can react according to the S_N2 mechanism.     

Synthesis and structure of [2 x 2] molecular grid copper(II) and nickel(II) complexes with a new polydentate oxime-containing Schiff base ligand

A new polynucleating oxime-containing Schiff base ligand, 2-hydroxyimino- N'-[1-(2-pyridyl)ethylidene]propanohydrazone (H pop), has been synthesized and fully characterized. pH potentiometric, electrospray ionization mass spectrometric, and spectrophotometric studies of complex formation in H 2O/DMSO solution confirmed the preference for polynuclear complexes with 3d metal ions. Single-crystal X-ray diffraction analyses of [Ni 4( pop) 4(HCOO) 4].7H 2O ( 1), [Cu 4( pop-H) 4(HCOOH) 4].H 2O ( 2), and [Cu 4( pop-H) 4(H 2O) 4].9H 2O ( 3) indicated the presence of a [2 x 2] molecular grid structure in all three compounds but distinct configurations of the cores: a head-to-tail ligand arrangement with overall S 4 symmetry of the grid in the Cu (2+) complexes as opposed to a head-to-head ligand arrangement with (noncrystallographic) C 2 grid symmetry for the Ni (2+) complex. A cryomagnetic study of 3 revealed intramolecular ferromagnetic exchange between copper ions in the grid, while in 1, antiferromagnetic interactions between the metal ions were observed.